Inox CEL-Fix Αντάπτορας M18 με Μεταλλικός Καταλύτης Ίσιο

This Oxygen Sensor CEL-Fix adaptor is a solution για vehicles με titanium oxide sensors ή "smart" Engine Control Units (ECUs) με sophisticated checks where an electronic oxygen sensor simulator cannot achieve the desired results. It is Universal και applies to almost all EOBD vehicles which have two oxygen sensors (one before και one after the catalytic converter). This CEL-Fix is used to restore a κανονικό signal για the oxygen sensor when the catalyst is removed ή replaced με a racing catalyst resulting in an error message (CEL-Check Engine Light) in the controller. Unlike simple designs that place the Oxygen Sensor just a bit away from the exhaust gas stream και prevent the CEL only για short term, our CEL-Fix adaptor has an integrated HJS mini-catalyst which actually improves the exhaust gas quality before it is measured by the Oxygen Sensor. It comes με an Oxygen Sensor Standard Thread M18x1.55 on each side για easy installation. The CEL-Fix adaptor MUST be installed ONLY on the second Oxygen Sensor which is always located after the Catalytic converter. Για vehicles με 2 parallel catalytic converters (Αριστερά και Δεξιά), must be used 2 CEL-Fix adaptors, always to the second Oxygen Sensor after the Καταλύτες. Warning: Never install the CEL-Fix adaptor to the first oxygen sensor (nearest to the engine) located in front of the catalytic converter, since it is responsible για proper information of the mixture because the CEL-Fix adaptor it will not work! Attention: After the installation of the adaptor you must take your car to a mechanic to switch off the CEL by computer!