CEL-Fix Αντάπτορας για Αισθητήρες Λάμδα με HJS Euro4 Καταλύτης

This Oxygen Sensor CEL-Fix is a solution για vehicles με titanium oxide sensors ή "smart" Engine Control Units (ECUs) με sophisticated checks where an electronic oxygen sensor simulator cannot achieve the desired results.It is Universal και applies to almost all EOBD vehicles which have two oxygen sensors (one before και one after the catalytic converter). This CEL-Fix is used to restore a κανονικό signal για the oxygen sensor after the catalytic converter when the catalyst is removed ή replaced με a racing catalyst resulting in an error message (CEL-Check Engine Light) in the controller. Unlike simple designs that place the sensor just a abit away from the exhaust gas stream και prevent the CEL only για short term, the CEL-Fix has an integrated mini-cat which actually improves the exhaust gas quality before it is measured by the sensor. It comes με an Oxygen Sensor Standard Thread M18x1, 5 on each side. Warning: The first oxygen sensor (nearest to the engine) located in front of the catalytic converter must never be replaced, since it is responsible για proper formation of the mixture! On engines με two separate και parallel working catalytic converters, two (2) sensors must be used.