Acero Inoxidable CEL-Fix Adaptador M18 con Catalizador Metálico Recto

This Oxygen Sensor CEL-Fix adaptor is a solution para vehicles con titanium oxide sensors  o "smart" Engine Control Units (ECUs) con sophisticated checks where an electronic oxygen sensor simulator cannot achieve the desired results. It is Universal y applies to almost all EOBD vehicles which have two oxygen sensors (one before y one after the catalytic converter). This CEL-Fix is used to restore a normales signal para the oxygen sensor when the catalyst is removed  o replaced con a racing catalyst resulting in an error message (CEL-Check Engine Light) in the controller. Unlike simple designs that place the Oxygen Sensor just a bit away from the exhaust gas stream y prevent the CEL only para short term, our CEL-Fix adaptor has an integrated HJS mini-catalyst which actually improves the exhaust gas quality before it is measured by the Oxygen Sensor. It comes con an Oxygen Sensor Standard Thread M18x1.55 on each side para easy installation. The CEL-Fix adaptor MUST be installed ONLY on the second Oxygen Sensor which is always located after the Catalytic converter. Para vehicles con 2 parallel catalytic converters (Izquierda y Derecha), must be used 2 CEL-Fix adaptors, always to the second Oxygen Sensor after the Catalizadores. Warning: Never install the CEL-Fix adaptor to the first oxygen sensor (nearest to the engine) located in front of the catalytic converter, since it is responsible para proper information of the mixture because the CEL-Fix adaptor it will not work! Attention: After the installation of the adaptor you must take your car to a mechanic to switch off the CEL by computer!