RVS CEL-Fix Adapter M18 met Metaal Katalysator recht

This Oxygen Sensor CEL-Fix adaptor is a solution voor vehicles met titanium oxide sensorsof"smart" Engine Control Units (ECUs) met sophisticated checks where an electronic oxygen sensor simulator cannot achieve the desired results. It is Universeel en applies to almost all EOBD vehicles which have two oxygen sensors (one before en one after the catalytic converter). This CEL-Fix is used to restore a normaal signal voor the oxygen sensor when the catalyst is removedofreplaced met a racing catalyst resulting in an error message (CEL-Check Engine Light) in the controller. Unlike simple designs that place the Oxygen Sensor just a bit away from the exhaust gas stream en prevent the CEL only voor short term, our CEL-Fix adaptor has an integrated HJS mini-catalyst which actually improves the exhaust gas quality before it is measured by the Oxygen Sensor. It comes met an Oxygen Sensor Standard Thread M18x1.55 on each side voor easy installation. The CEL-Fix adaptor MUST be installed ONLY on the second Oxygen Sensor which is always located after the Catalytic converter. Voorvehicles met 2 parallel catalytic converters (Links en Rechts), must be used 2 CEL-Fix adaptors, always to the second Oxygen Sensor after the Katalysatoren. Warning: Never install the CEL-Fix adaptor to the first oxygen sensor (nearest to the engine) located in front of the catalytic converter, since it is responsible voor proper information of the mixture because the CEL-Fix adaptor it will not work! Attention: After the installation of the adaptor you must take your car to a mechanic to switch off the CEL by computer!