CEL-Fix Adapter voor Lambda Sensors met HJS Euro4 Katalysator

This Oxygen Sensor CEL-Fix is a solution voor vehicles met titanium oxide sensorsof"smart" Engine Control Units (ECUs) met sophisticated checks where an electronic oxygen sensor simulator cannot achieve the desired results.It is Universeel en applies to almost all EOBD vehicles which have two oxygen sensors (one before en one after the catalytic converter). This CEL-Fix is used to restore a normaal signal voor the oxygen sensor after the catalytic converter when the catalyst is removedofreplaced met a racing catalyst resulting in an error message (CEL-Check Engine Light) in the controller. Unlike simple designs that place the sensor just a abit away from the exhaust gas stream en prevent the CEL only voor short term, the CEL-Fix has an integrated mini-cat which actually improves the exhaust gas quality before it is measured by the sensor. It comes met an Oxygen Sensor Standard Thread M18x1, 5 on each side. Warning: The first oxygen sensor (nearest to the engine) located in front of the catalytic converter must never be replaced, since it is responsible voor proper formation of the mixture! On engines met two separate en parallel working catalytic converters, two (2) sensors must be used.