CEL-Fix Adaptör için Lambda Sensörleri ile HJS Euro4 Katalitik Konvertör

This Oxygen Sensor CEL-Fix is a solution için vehicles ile titanium oxide sensors veya"smart" Engine Control Units (ECUs) ile sophisticated checks where an electronic oxygen sensor simulator cannot achieve the desired results. It is evrensel veapplies to almost all EOBD vehicles which have two oxygen sensors (one before veone after the catalytic converter). This CEL-Fix is used to restore a normal signal için the oxygen sensor after the catalytic converter when the catalyst is removed veyareplaced ile a racing catalyst resulting in an error message (CEL-Check Engine Light) in the controller. Unlike simple designs that place the sensor just a abit away from the exhaust gas stream veprevent the CEL only için short term, the CEL-Fix has an integrated mini-cat which actually improves the exhaust gas quality before it is measured by the sensor. It comes ile an Oxygen Sensor Standard Thread M18x1, 5 on each side. Warning: The first oxygen sensor (nearest to the engine) located in front of the catalytic converter must never be replaced, since it is responsible için proper formation of the mixture! On engines ile two separate veparallel working catalytic converters, two (2) sensors must be used.