Edelstahl CEL-Fix Adapter M18 mit Metall Katalysator Gerader

This Oxygen Sensor CEL-Fix adaptor is a solution für vehicles mit titanium oxide sensors  oder"smart" Engine Control Units (ECUs) mit sophisticated checks where an electronic oxygen sensor simulator cannot achieve the desired results. It is Universal  undapplies to almost all EOBD vehicles which have two oxygen sensors (one before  undone after the catalytic converter). This CEL-Fix is used to restore a normal signal für the oxygen sensor when the catalyst is removed  oderreplaced mit a racing catalyst resulting in an error message (CEL-Check Engine Light) in the controller. Unlike simple designs that place the Oxygen Sensor just a bit away from the exhaust gas stream  undprevent the CEL only für short term, our CEL-Fix adaptor has an integrated HJS mini-catalyst which actually improves the exhaust gas quality before it is measured by the Oxygen Sensor. It comes mit an Oxygen Sensor Standard Thread M18x1.55 on each side für easy installation. The CEL-Fix adaptor MUST be installed ONLY on the second Oxygen Sensor which is always located after the Catalytic converter. Fürvehicles mit 2 parallel catalytic converters (Links  undRechts), must be used 2 CEL-Fix adaptors, always to the second Oxygen Sensor after the Katalysatoren. Warning: Never install the CEL-Fix adaptor to the first oxygen sensor (nearest to the engine) located in front of the catalytic converter, since it is responsible für proper information of the mixture because the CEL-Fix adaptor it will not work! Attention: After the installation of the adaptor you must take your car to a mechanic to switch off the CEL by computer!